Hydro Jetting in Tyler

What fails under Tyler homes

Older Pacific Northwest neighborhoods were built with concrete and clay side sewers, sometimes with sections of Orangeburg (tar-impregnated fiber) pipe from the 1950s and 60s that has since deformed. Cast iron runs under the house; the side sewer to the street is often long and deep on hillside lots.

Wet ground for much of the year, big root systems from firs, cedars, and maples, and hillside soils that creep downslope all work on sewer joints. Groundwater makes open trenches slow and messy, and many side sewers run under sidewalks and streets that the city requires be restored to standard.

Lining handles the root-intruded clay and concrete; bursting replaces the Orangeburg and collapsed runs; both avoid digging up a wet hillside yard or cutting a city street.

What a jetter does that a cable cannot

A hydro jetter pushes water through a nozzle at several thousand PSI. Rear-facing jets pull the hose down the line and scour everything off the pipe wall: roots, grease, sludge, mineral scale, and the rust flakes inside old cast iron. A cable machine drills a hole through the blockage and leaves the rest on the wall, which is why cabled lines re-clog on a schedule.

Where it fits in a repair

Jetting is step one before lining, because a liner has to bond to clean pipe, and step one before an honest camera inspection, because a line full of roots or scale hides its own condition. It is also legitimate maintenance on its own for a structurally sound line that roots keep finding.

When a line should not be jetted

Cast iron that is paper-thin at the bottom can be opened up by an aggressive descaling pass. A collapsed clay section will not let the hose through. Orangeburg can delaminate under pressure. An experienced operator checks the line first, matches the nozzle to the material, and stops if the pipe is not holding up.

Maintenance versus repair

If the camera shows sound pipe, annual or semiannual jetting is a cheap way to stay ahead of roots. If it shows open joints, channeled cast iron or offsets, jetting is a stopgap and the money is better spent on lining, which removes the joints the roots are using.

Getting it done in Tyler

A camera inspection maps the line and marks every defect on the ground with its depth. The line is cleaned with a hydro jetter so the pipe wall can be seen and, if it is being lined, so the resin bonds to clean pipe. Lining works from the cleanout at the house; bursting needs a small pit at each end of the run. Either way the yard, driveway and slab in between are never opened. Most residential jobs in Tyler finish in a day, and you should receive the before-and-after footage as part of the job.

Permits are part of it. Lateral work in Tyler normally needs a plumbing permit, and anything in the sidewalk, parkway or street needs a right-of-way permit as well. The contractor pulls those and schedules the inspection; if a quote does not mention them, ask.

Finding the right contractor in Tyler

Tyler does not have a CIPP Verified installer assigned yet. The curedinplacepipe.net directory lists vetted lining contractors by state. The form below and (877) 880-8125 both reach our network directly; we match the request with a qualified contractor covering Tyler. Estimates are free. Call now.

More trenchless services in Tyler

Questions we hear in Tyler